Fantastic product. More features than the brand name product and much less expensive
It looks and functions great. No issues and great purshcase for installing my 12v power suppply for my Starlink setup.
Upgrade Your Lid with Helmet Accessories
A helmet is only as good as the extras that keep vision clear, comfort high, and communication on point. Our Helmet Accessories collection pulls together tear-offs, replacement visors, dirt deflectors, spoiler peaks, hydration ports, and hardware kits that fit Impact, Stilo, Pyrotect, PyroCell, and PCI carbon lids. Whether you need a stack of 10-mil clear films for a silt section or a fresh visor screw kit before a tech inspection, this page has you covered.
Key Items in Stock
- 20-Pack 10 mil Tear-Offs – laser-cut for Impact Air Draft and Stilo ST5 shields.
- Anti-Fog Double-Pane Shield – polycarbonate lens with perimeter bead that snaps into Impact Carbon SXS helmets.
- Orange Desert Peak – sun visor for PyroCell X — molded vents cut glare without trapping dust.
- Hydration Side Port Kit – bulkhead, bite-valve, and tether; install in five minutes with a step drill.
- Helmet Skirt w/ Dust Seal – Kevlar-blend skirt that Velcros to most SA2020 shells; blocks silt and fumes.
- Spare Visor Screw & Washer Set – six 6 mm pan heads and nylon washers to replace stripped hardware.
- Noise-Cancel Mic Boom – Nexus 4-pin electret boom pre-wired for PCI helmet kits; plug-and-race.
Why These Accessories Matter
Vision and comms win races. Quality tear-offs mean no micro-scratches under gritty sand; anti-fog shields keep your sightline clear when humidity spikes in river crossings. Dust skirts stop micron-level silt from choking lungs and radios. Hydration ports keep electrolytes flowing without fumbling for bottles. Small parts, big lap-time savings.
Compatibility Cheatsheet
Impact: Air Draft, Carbon SXS, Axis — uses M6 posts and 12.125″ tear-offs
Pyrotect: ProSport, ProAirflow SA2020 — fits 9-hole peaks and 11.5″ shields
Stilo: ST5, ST5.1 — accepts Stilo tear-offs and magnetic quick-release visors
Quick Install Tips
- Stack tear-offs from tab left to tab right; pull toward the cage roof to avoid visor scratches.
- Use blue Loctite on visor screws—red will crack nylon washers.
- Hydration bulkhead: drill at 8 o’clock for right-hand drink tubes, 4 o’clock for left-hand drivers.
Pro Tip
Label tear-off tabs with lap numbers using a silver paint pen. Pull the tag at each pit stop so your GoPro footage always shows a fresh POV for sponsors.
