Awesome piece of gear, i bought one for my dad and he loved it!
Upgrade Your Lid with Helmet Accessories
A helmet is only as good as the extras that keep vision clear, comfort high, and communication on point. Our Helmet Accessories collection pulls together tear-offs, replacement visors, dirt deflectors, spoiler peaks, hydration ports, and hardware kits that fit Impact, Stilo, Pyrotect, PyroCell, and PCI carbon lids. Whether you need a stack of 10-mil clear films for a silt section or a fresh visor screw kit before a tech inspection, this page has you covered.
Key Items in Stock
- 20-Pack 10 mil Tear-Offs – laser-cut for Impact Air Draft and Stilo ST5 shields.
- Anti-Fog Double-Pane Shield – polycarbonate lens with perimeter bead that snaps into Impact Carbon SXS helmets.
- Orange Desert Peak – sun visor for PyroCell X — molded vents cut glare without trapping dust.
- Hydration Side Port Kit – bulkhead, bite-valve, and tether; install in five minutes with a step drill.
- Helmet Skirt w/ Dust Seal – Kevlar-blend skirt that Velcros to most SA2020 shells; blocks silt and fumes.
- Spare Visor Screw & Washer Set – six 6 mm pan heads and nylon washers to replace stripped hardware.
- Noise-Cancel Mic Boom – Nexus 4-pin electret boom pre-wired for PCI helmet kits; plug-and-race.
Why These Accessories Matter
Vision and comms win races. Quality tear-offs mean no micro-scratches under gritty sand; anti-fog shields keep your sightline clear when humidity spikes in river crossings. Dust skirts stop micron-level silt from choking lungs and radios. Hydration ports keep electrolytes flowing without fumbling for bottles. Small parts, big lap-time savings.
Compatibility Cheatsheet
Impact: Air Draft, Carbon SXS, Axis — uses M6 posts and 12.125″ tear-offs
Pyrotect: ProSport, ProAirflow SA2020 — fits 9-hole peaks and 11.5″ shields
Stilo: ST5, ST5.1 — accepts Stilo tear-offs and magnetic quick-release visors
Quick Install Tips
- Stack tear-offs from tab left to tab right; pull toward the cage roof to avoid visor scratches.
- Use blue Loctite on visor screws—red will crack nylon washers.
- Hydration bulkhead: drill at 8 o’clock for right-hand drink tubes, 4 o’clock for left-hand drivers.
Pro Tip
Label tear-off tabs with lap numbers using a silver paint pen. Pull the tag at each pit stop so your GoPro footage always shows a fresh POV for sponsors.
